|
|
Product list:
HOTP7155 CARDMAKERS CLASSIC INSTANT CARD ART
HOTP7235 CARDMAKERS CLASSIC CREATIVE PACK
HOTP7507 CARDMAKERS CLASSIC RIBBONS
General supplies
Cardstock or folded cards
Adhesives
3D Foam Pads
Black Peel Offs
Equipment
SCISSORS
RULER
CRAFT KNIFE
SANDPAPER OR EMERY BOARD
Step by step
1. Fold an A4 piece of card into a Zig Zag
2. Select the ‘swirly’ card art sheet and remove all pieces. Use sandpaper and give all edges an ‘aged’ look
3. Choose two co-ordinating papers. From one, cut two panels approximately 20.5cm x 9.5cm. Cut one panel from the other piece the same size. From the second piece, tear pieces across so that the white edge shows and ink this edge.
Apply this to the two main panels on the bottom corners (opposite). Trim to fit, then attach the fleur de lys panel to the corner. Attach these panels to the two outer panels and the one piece to the middle panel.
4. Make a bow from burgundy grosgrain ribbon. Attach swirly panel to centre of left hand panel and attach to the card art. Attach the torn corner over the swirly panel and apply the fleur de lys.
5. On centre panel, attach the blank plaque centrally using foam pads and apply peel off sentiment. Attach fleur de lys pieces at the top and bottom of the plaque.
6. On right hand side panel, cut ribbon to approximately 16cm long. Cut the ends to points. Fold and attach to the back of the black/red circle panel so that it sits in a diamond position centrally and attach a ‘corner’ either side of the diamond.
<<< Back to Projects
|
